注: 建议图片大小150px*50px 
SERVICE - Used for fastening the connection between air hose couplings and rubber hoses to prevent the hose from falling off under vibration and pressure. It is necessary to select the corresponding specifications for use based on the outer diameter of the hose.
FEATURES - The hose clamp has two inner pads that can be adjusted by screws to allow for a certain range of changes in the clamping size of the product. Even if the thickness of the hose is different, it will not affect the use effect. The hose clamp adopts high-strength ductile iron casting technology, which has good strength and toughness. After clamping, it has a high adhesion force with the rubber tube and is very firm. The hose clamp can be used alone or in combination, and there is no damage to the hose during use. It can be installed multiple times. The size of the hose clamp ranges from a minimum of 22mm to a maximum of 400mm, and each product is labeled with a size range. Regardless of the size of the hose, the appropriate size can be found.
CONNECTION - Insert the hose clamp into the appropriate position of the hose and gradually tighten the hose by rotating the nuts on both sides. When tightening the nut, it is necessary to gradually tighten the nuts on both sides in a cyclic manner to achieve the best effect.
DISCONNECTION -Use the corresponding wrench to loosen the nuts on both sides counterclockwise until the hose clamp is no longer in contact with the rubber hose, then it can be swapped or removed. Remember to ensure that the equipment has stopped and the pressure inside the hose is maintained before operation.
SERVICE - Used for fastening the connection between air hose couplings and rubber hoses to prevent the hose from falling off under vibration and pressure. It is necessary to select the corresponding specifications for use based on the outer diameter of the hose.
FEATURES - The hose clamp has two inner pads that can be adjusted by screws to allow for a certain range of changes in the clamping size of the product. Even if the thickness of the hose is different, it will not affect the use effect. The hose clamp adopts high-strength ductile iron casting technology, which has good strength and toughness. After clamping, it has a high adhesion force with the rubber tube and is very firm. The hose clamp can be used alone or in combination, and there is no damage to the hose during use. It can be installed multiple times. The size of the hose clamp ranges from a minimum of 22mm to a maximum of 400mm, and each product is labeled with a size range. Regardless of the size of the hose, the appropriate size can be found.
CONNECTION - Insert the hose clamp into the appropriate position of the hose and gradually tighten the hose by rotating the nuts on both sides. When tightening the nut, it is necessary to gradually tighten the nuts on both sides in a cyclic manner to achieve the best effect.
DISCONNECTION -Use the corresponding wrench to loosen the nuts on both sides counterclockwise until the hose clamp is no longer in contact with the rubber hose, then it can be swapped or removed. Remember to ensure that the equipment has stopped and the pressure inside the hose is maintained before operation.
